
PAGE 4
User Manual PS 155 / October 2013 © ASL Intercom BV
.
fine tuning the low frequencies. See section 7.0
6 TEST TONE button
By pushing this recessed button the built-in test
tone generator is activated. The test tone assists
in obtaining the best possible side tone rejection.
See section 7.0
7 VOX LEVEL trimmer
This trimmer adjusts the detection level of the
VOX switch. As soon as the VOX circuitry detects
an audio signal on the intercom party line that is
louder than the level set by this trimmer, the
wireless unit goes from receive mode to transmit
mode. See section 8.0 for the VOX adjustment
procedure.
8 VOX RELEASE trimmer
After the audio signal of the intercom party line
falls below the set VOX level, the wireless unit
stays in transmit mode for a period of time that is
preset by this trimmer. See section 8.0 for the
VOX adjustment procedure.
9 TX CONTROL select switch
This switch has the positions VOX, CALL and
PTT, each indicating the way the wireless unit is
triggered to go from receive mode to transmit
mode. See section 5.0
10 POWER LED
This LED is lit when the PS 155 is powered by the
intercom line.
11 Rx/Tx LED
This LED is lit green when the wireless unit is in
receive mode and lit red when the wireless unit is
in transmit mode. See also section 5.0.
4.0 REAR PANEL CONNECTORS
12 LINE connectors
These male and female XLR-3 connectors are for
connecting the PS 155 to the intercom party line.
Pin assignments:
Pin 1: 0 V / ground shield
Pin 2: +30 V power wire
Pin 3: audio wire
13 TO TRANSCEIVER connector
This Sub-D 9 pole connector is for connecting the
PS 155 to the wireless unit. The connector is also
used to connect an external PTT switch to the PS
155.
For pin assignment and further details, see
section 6.0.
Comentarios a estos manuales