ASL INTERCOM PS 155 Manual de usuario Pagina 8

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 12
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 7
PAGE 8
User Manual PS 155 / October 2013 © ASL Intercom BV
.
8.0 VOX ADJUSTMENT PROCEDURE
Before starting this procedure make sure that the
party line side tone has been properly adjusted
(see section 7.0) !
To adjust the VOX, proceed as follows:
Put the TX CONTROL select switch to
VOX
Turn the LEVEL and RELEASE trimmers
counter clockwise
Connect an intercom user station to the
party line, connect a headset to that
station and speak into the microphone of
headset
With the LEVEL trimmer adjust the audio
level on the party line to which the PS 155
should trigger the wireless unit to go from
receive mode to send mode (the Rx/Tx
LED changes from green to red)
With the RELEASE trimmer adjust the
release time of the VOX switch
The attack time of the VOX switch can be
adjusted by internal trimmer R9, see section 9.0.
9.0 INTERNAL CONTROLS
To access the internal trimmers the PS 155 needs to be opened. Before doing so, disconnect the unit of
all other equipment. Open the PS 155 by removing the two screws of the cover at either side. Then
connect the PS 155 to the intercom party line and to the wireless unit.
OUTPUT GAIN trimmer (R4)
With this trimmer the output gain can be adjusted.
The trimmer is located on the PCB board at the
left, near to the transformers.
To increase the gain, turn clockwise.
To decrease the gain, turn counter clockwise.
VOX DETECT trimmer (R9)
With this trimmer the attack time of the VOX
switch can be adjusted. Proceed as follows:
Set the TX CONTROL select switch to
position “VOX”
Connect a user station to the intercom
party line and connect a headset to that
station
Speak into the headset microphone
First adjust the LEVEL and RELEASE
trimmers at the front panel
Then adjust the attack time with trimmer
R9
Vista de pagina 7
1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios