ASL INTERCOM VAR8-ACU Series Manual descargar pdf (Pagina 40)

EAP01 - Product Manual

7.4 Installing the EAP01 Front Panel/Electronics Assembly

The following procedure describes how to install the EAP01 Front Panel/Electronics Assembly into the back

box.

The following tools are required to replace the Front Panel/Electronics Assembly:

• A small flat bladed screwdriver.

• A 2.5 mm Allen key or driver.

Installing the Front Panel/Electronics Assembly:

1. Connect the new front panel assembly as follows, see Figure 20:

a. Plug the flying leads to the multi-way connectors on the electronics assembly.

b. Secure the flying leads to the front panel using the P-clip provided.

Figure 20 EAP01 Front Panel/Electronics Assembly

BS VERSION 5 OR LATER

BS VERSION < 5

P-CLIP

7-WAY CONNECTOR

6-WAY CONNECTOR

7-WAY CONNECTOR

6-WAY CONNECTOR

P-CLIP

FLYING LEAD

DIP switch on microphone PCB is NOT used.

Issue: 02 complete, approved

Page 40 of 52

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Sin comentarios

ASL INTERCOM VAR8-ACU Series Manual Pagina 40